Opinion wanted on running FSX
Results 1 to 12 of 12

Thread: Opinion wanted on running FSX

  1. #1

    Opinion wanted on running FSX

    All I got a new PC (well new to me) it's a HP DC5800 SFF. It's an Intel core Duo 3.0ghz CPU with 4 gigs (upgradeable to 8 gigs) of Ram and an ATI HD2400 256mb video card. I have Vista Home Premium. Is enough to give FSX a try?

    Thanks,

    T.

  2. #2
    The only questionable part might be the Graphics Card. 256meg of RAM might put it right on the edge of being able to run the sim. The CPU and RAM are what I have with just a Dual Core setup and I do very well. You'll get many opinions yet so I'll just say that out of the entire setup, the GPU seems to be the weak link.
    USAF Retired, 301st Fighter Wing, Carswell AFB, Texas
    My SOH Uploads: http://www.sim-outhouse.com/sohforum...erid=83&sort=d

    Current System Specs:
    FSX/Accel | Windows10 64bit
    Motherboard: MSI760GM-E51(MS-7596)
    CPU: 3.9GHz AMD FX-4300 Quad-Core | RAM: 16GB DDR3 1333
    GPU: NVidia GTX 970 (4GB GDDR5)

  3. #3
    My PC would be roughly similar in specs and I did use a 256mb card but it was very marginal for FSX to say the least. I have since upgraded to a 1GB card and it's now quite reasonable - not outstanding though by any stretch. I tend to fly simple aircaft (ie not tubeliners) in VFR conditions into detailed scenery (Orbx) - works fine for that.

  4. #4
    Thanks guys, I'll look around for another card that will work. I was also thinking about bumping up the ram.

    T.

  5. #5
    4 GB of RAM is likely sufficient as FSX is a 32 bit program and cannot take advantage of any more than 4 GB. Also, if you are using a 32 bit operating system you cannot use more than 4 GB of RAM. There may be an advantage to using 6 or 8 GB of RAM with a 64 bit OS. The operating system also considers the RAM on the video card and the cache on the CPU to be a part of the RAM it recognizes, so with a 32 bit OS, 4 GB of system RAM, and a 2 GB video card your OS would only address 2 GB of your system RAM minus the amount on the CPU.

    I agree, the video card is weak for FSX. The CPU is ok, but you will not be able to turn the graphics sliders in FSX beyond the medium points. Back when I had a Core2Duo 3.0 GHz CPU I found that overclocking the CPU to 3.6 GHz significantly improved frame rates and smoothness to the point I could move the sliders to about 75% of maximum. I did use an aftermarket CPU cooler for over clocking, stock coolers typically do not have the cooling capacity to dissipate the additional heat.
    My computer: ABS Gladiator Gaming PC featuring an Intel 10700F CPU, EVGA CLC-240 AIO cooler (dead fans replaced with Noctua fans), Asus Tuf Gaming B460M Plus motherboard, 16GB DDR4-3000 RAM, 1 TB NVMe SSD, EVGA RTX3070 FTW3 video card, dead EVGA 750 watt power supply replaced with Antec 900 watt PSU.

  6. #6
    You are borderline and need to use all available tricks of the trade. I am running a 2.8 ghz I7 with 6 gigs ram but a 5870 1 gig card and Vista 64. Being right on that edge its important to have a healthy hard drive. Defrag it, have plenty of space open for virtual memory, me 4 gigs minimum. Also close all background progs that are not needed. I use ENDITALL"freeware" to do a basic closure of those I am sure are not needed. Temp disable antivirus ect.....
    Then look into this http://www.venetubo.com/fsx.html

    I ran this and it got me a much needed boost in my all around performance. Basically its a tweak tool for dummies.

    Using all of the above and in game and card setting tweaking on my own, I have stretched out my computer longer than any other I have ever owned. And I run about every know payware addon known to man.

  7. #7
    Quote Originally Posted by SgtT View Post
    Thanks guys, I'll look around for another card that will work. I was also thinking about bumping up the ram.

    T.
    save the money when it comes to the RAM...your good enough there

    spend it on the card...1Gig is the min. GPU ram needed -

    primary concern with FSX is the speed of your processor, so buy what you can afford and then tweak the fsx.cfg to the bejeebers and gone
    enter..the Sandman

    visit Heywood Planes - YouTube

  8. #8
    Thanks guys, I appreciate everyone's feedback. Maybe I'll wait until I can get a better video card. One issue is since the PC is a small form factor it would have to be a low profile card. The other issue is the power supply is only 240 watts.

    I don't think a standard power supply will fit in the HP DC5800 SFF.

    T.

  9. #9
    Retired SOH Administrator
    Join Date
    Jun 2005
    Location
    Hampton,Va
    Age
    69
    Posts
    4,251
    Most higher end video cards require a separate PS going to the card. Looking at the PS you have may cause some problems. Also I don't think you MB will be able to handle it either. You might want to go into MSCONFIG and disable everything, reboot Windows and it will only load what it needs to run the operation system. You will know from there if FSX will work right on your system. Good luck...Mike
    [SIGPIC][/SIGPIC]Asus Rampage Extreme Motherboard /EVGA AR GeForce GTX 295 1792MB 896 Bit GDDR3 /Corsair 8gig XMS DDR3/Intel Core 2 Extreme QX 9770 Yorkfield OCed 4.2 LGA 775/136W Quad Core / Water Cooled/ 2 WD Raptor 150gig 10,000 rpm Drives in Raid O Mode/WD Raptor 150gig internal back up/400 gig External WD back up Drive/Thermaltake 1200 Watt PS/Sony Dual Layer DVD RD/RW/Plextor DVD/RW/ Thermaltake Kandalf Tower/ Sound Blasters X-FI Platinum / X52 Pro

  10. #10
    Quote Originally Posted by SgtT View Post
    Thanks guys, I appreciate everyone's feedback. Maybe I'll wait until I can get a better video card. One issue is since the PC is a small form factor it would have to be a low profile card. The other issue is the power supply is only 240 watts.

    I don't think a standard power supply will fit in the HP DC5800 SFF.

    T.
    Yikes!!! a 240 watt PSU is not going to run a high end video card, at least not for long. Custom form factors are another issue and a reason I would not have a Gateway, HP, E-machine, etc. for a custom gaming/sim rig.
    My computer: ABS Gladiator Gaming PC featuring an Intel 10700F CPU, EVGA CLC-240 AIO cooler (dead fans replaced with Noctua fans), Asus Tuf Gaming B460M Plus motherboard, 16GB DDR4-3000 RAM, 1 TB NVMe SSD, EVGA RTX3070 FTW3 video card, dead EVGA 750 watt power supply replaced with Antec 900 watt PSU.

  11. #11
    I'm amazed that we still have people wondering about performance of FSX, it's almost 6 years since its release. How many other PC "games" of this age still raise questions and enthusiasm, most are forgotten relics consigned to the dusty shelf. BTW I'm not criticising the OP just revelling in our chosen hobby.
    Intel i5-10600K 4.10 GHz 12 Core CPU
    Asus ROG Strix Z590-E Gaming LGA1200 Z590-E Motherboard
    Corsair Vengeance LPX 32GB (4 x 8GB) DDR4-3200 Memory
    Water Cooler - CORSAIR iCUE H100i RGB PRO XT
    Corsair 850W PSU
    MSI RX580 Radeon Armor 8Gb
    Windows 10 Home Premium 64
    3 x 21" Acer LED screens

  12. #12
    I think that Microsoft looked for the future almost with every Flight Simulator version. With FSX it "did bet the wrong horse" imaging that the processor speed would soon go over the 4 GHz barrier. It didn't but turned for the "multicore course". Service packs tried to correct the situation, but the real solution to the problem never game out (FS11) when MS kicked the devoloping team out. I don't know, but this is my guess.

    Pekka

Members who have read this thread: 64

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •