RAF Carew Cheriton

[Motormouse]

A new entry has been added to Add-Ons Library, category FS 2004 Scenery

Description: Here is another of my ez scenery / Afcad creations for fs9/2004


This time its RAF Carew Cheriton in Pembrokeshire, South Wales, prompted by Huub's repaint of an Avro Anson that was based there.


Carew Cheriton 4.6 miles nw of Tenby, was built on the site of the earlier WW1 Balloon station ,RNAS Pembroke which had been decommissioned and sold off during the inter-war period.
However WW2 saw the large RAF Coastal Command base at RAF Pembroke Dock in need short range escort and anti-submarine units to support operations, this resulted in the re-opening of the old airship station and utilising additional fields to build a three runway airfield for No. 15 Group RAF.


Construction commenced in 1938,and the airfield re-opened in April 1939, some months before the start of the Second World War. Three concrete runways were built by the early 1940s, including two Bellman hangars and two Bessonneau hangars. (later replaced by Blister hangars. With the airfield being used as a support station for the flying boat operations at RAF Pembroke Dock, instead of using the old name of Pembroke, it was renamed as RAF Carew Cheriton which enabled it to be distinguished from RAF Pembroke Dock. Operational until 942 the airfield was then handed over to Flying Training Command; and became No:10 , Radio School until it was closed in 1945; the airfield then reverted to 'care and maintenance', was briefly active again in 1950's as home to Pembroke Dock Station flight; and was last used by RN Wessex helicopters on exercise in June of 1976

The tower is now a museum, https://www.carewcheritoncontroltower.co.uk/ and is a unique design being a representation in brick of the first tower that was there; which was made from the salvaged wheelhouse (in wood) of the wrecked SS Montrose (of Dr Crippen infamy) https://en.wikipedia.org/wiki/SS_Montrose_(1897)
and which was put in place when the airfield originally opened as a Royal Navy balloon station in ww1

I've used static objects by the usual suspects...Ted Andrews, Sid Schwartz, the UKvfr Library, Airfield Construction Group (Duxford and Coningsby sceneries) Exclude file included but no ground poly ( my system won't run Sbuilder )

To check it out, rate it or add comments, visit RAF Carew Cheriton
The comments you make there will appear in the posts below.

[huub vink]

Thanks Pete!



Cheers,
Huub

[Motormouse]

Thanks Pete!



Cheers,
Huub

Have you made your way to the southern hangar and dispersal yet?

It's a somewhat unique airfield the perimeter track doesn't go all the way around for aeroplanes it goes to the bomb and armament stores when it was the balloon station

Ttfn

Pete

[ian elliot]

This one could use ground poly's, here we go, thanks Pete

[huub vink]

Thank Ian! Pete, can you please insert the ground poly file in your upload?

To answer Pete's question, yes I've been there. Looking at the truck it must be a low gravity area. I think it is caused by my install as the same truck are normally at the ground at the other locations.



But I prefer the area below anyway. I love busy airfields and from what I have been reading Carew Cheriton was quite busy.



There is one odd thing, I think the location for "active runway" is a bit odd.....



And yes I'm doing a complete useless re-texturing of the Alphasim Hudson......

Cheers,
Huub

[Motormouse]

Thank Ian! Pete, can you please insert the ground poly file in your upload?

To answer Pete's question, yes I've been there. Looking at the truck it must be a low gravity area. I think it is caused by my install as the same truck are normally at the ground at the other locations.



But I prefer the area below anyway. I love busy airfields and from what I have been reading Carew Cheriton was quite busy.



There is one odd thing, I think the location for "active runway" is a bit odd.....



And yes I'm doing a complete useless re-texturing of the Alphasim Hudson......

Cheers,
Huub

Probably won't get around to it ( adding/ correcting) until later in the week; got family Christmas stuff to do

Thanks for the poly Ian!

Ttfn

Pete

[Desert Rat]

Thank Ian! Pete, can you please insert the ground poly file in your upload?

Cheers,
Huub

I've taken the liberty of adding it to the original upload.

[huub vink]

I've taken the liberty of adding it to the original upload.

Thanks Jamie

Huub

[Motormouse]

Thanks Jamie

Huub

seconded; here's fix for start position and the floating fuel trucks Carew FIX.zip

use the 2 bgl files to replace the same ones that are in original upload.

ttfn

Pete

[Desert Rat]

seconded; here's fix for start position and the floating fuel trucks Carew FIX.zip

use the 2 bgl files to replace the same ones that are in original upload.

ttfn

Pete

Fix applied to original download also.

Grabbed Huub's Hudson skin whilst I was at it, many thanks, beautiful as always..

[Motormouse]

Fix applied to original download also.

Grabbed Huub's Hudson skin whilst I was at it, many thanks, beautiful as always..

Jamie you're a star thanks

ttfn

Pete

[huub vink]

Thanks guys! As you can see gravity has been restored in this area.... And the active runway has become a more logical spot as well.

Cheers,
Huub

[Motormouse]

Thanks guys! As you can see gravity has been restored in this area.... And the active runway has become a more logical spot as well.

Cheers,
Huub

That's the Underground fuel tank loop road ; but I think you're off to the station Chapel and gym in the background ( in its correct place btw)

Ttfn

Pete