Hi,
When I load the new VeloCity, every time I load it, either in 2D or VR the seating position is in the back of the aircraft. Does anyone else have this problem?
Regards,
Ian
Hi,
When I load the new VeloCity, every time I load it, either in 2D or VR the seating position is in the back of the aircraft. Does anyone else have this problem?
Regards,
Ian
Have you checked the cameras? It may be set on copilot? Perhaps, not the same. However, in the past few days I have had a lot of position jumping within or just outside the aircraft. One moment I will be in the correct seating position and the next facing 45 degrees to the left, or maybe two feet above the canopy. Then I will pop back into position. I don't know if it is SU 7 or my graphics card?
John
***************************
My first SIM was a Link Trainer. My last was a T-6 II
AMD Ryzen 7 7800 X3D@ 5.1 GHz
32 GB DDR5 RAM
3 M2 Drives. 1 TB Boot, 2 TB Sim drive, 2 TB Add-on Drive, 6TB Backup data hard drive
RTX 3080 10GB VRAM, Meta Quest 3 VR Headset
Many thanks for your reply Jmig. It's strange because with every other aircraft things are fine. Regarding the cameras I only have two settings, cockpit & external because I don't like messing with the camera settings because I tried once before and buggered the whole thing up resulting in a complete re-install
Ian
When I load it in my view is in the correct position but I noticed if I open the camera tab from the tool bar handle at the top of the screen and select either close or landing I get what you describe.
Also I have seen it mentioned in a couple of SU7 reviews on YouTube so it sounds like a bug that should get fixed by Asobo at some point
You can always use the arrow keys to move it and set it as a custom view for now until they fix it.
Asus ROG Maximus XI Hero
i9-9900K
32Gb Corsair Vengeance Pro DDR4 3200MHz
MSI RTX 2080Ti Ventus
Corsair H115i Cooler
Corsair RM850X PSU
Phanteks Evolv X case
Asus VG32G Monitor 2560x1440
Win 10
Oculus Quest 2
Logitech G29
Saitek X56
Saitek Pro Pedals
Saitek Cessna Trim Wheel
Thanks for that DB, I'll give that a try.
Ian
Bookmarks