I downloaded Prepar3D_v3_Academic_3.2.3.16769 today and I am wondering if I have to uninstall the complete P3D V2.2 or just uninstall the P3D Client to install the upgrade.
I downloaded Prepar3D_v3_Academic_3.2.3.16769 today and I am wondering if I have to uninstall the complete P3D V2.2 or just uninstall the P3D Client to install the upgrade.
Cheers
Pat
"Some people might say that freedom is being alone in the bush with the only sounds being the murmurs from the birds ... but I believe freedom is at 5000 feet with no other sound than the engine roaring."- William Hutchison, a young man taken from us far too young (16).
V2.x and V3.x are different sims, so you can have both installed at the same time. It's NOT an upgrade for V2.x
My mistake Dave. I should have said P3D V3.2. This is an upgrade from V3.2.2 to V3.2.3.
Cheers
Pat
"Some people might say that freedom is being alone in the bush with the only sounds being the murmurs from the birds ... but I believe freedom is at 5000 feet with no other sound than the engine roaring."- William Hutchison, a young man taken from us far too young (16).
I think you can start with the client and if you encounter problems you can update other components. As far as I know you don't damage anything if you start with the client first.
Thanks mate.
Cheers
Pat
"Some people might say that freedom is being alone in the bush with the only sounds being the murmurs from the birds ... but I believe freedom is at 5000 feet with no other sound than the engine roaring."- William Hutchison, a young man taken from us far too young (16).
Best to do both "client" and "content" otherwise you'll get issues with some add-ons that use in-sim menus such as AI Carriers.
I have just done the Client for now. Nice to see the Selection Menu is back. Can now use commands like ALT+E+S for vehicle selection or ALT+W+A for airport selection.
Cheers
Pat
"Some people might say that freedom is being alone in the bush with the only sounds being the murmurs from the birds ... but I believe freedom is at 5000 feet with no other sound than the engine roaring."- William Hutchison, a young man taken from us far too young (16).
Unfortunately the problem with the CH Yokes and pedals has not been rectified. It shows "CH Yoke" in the Controls panel but it still doesn't read the input from the levers. Still have to set things up in FSUIPC.
Cheers
Pat
"Some people might say that freedom is being alone in the bush with the only sounds being the murmurs from the birds ... but I believe freedom is at 5000 feet with no other sound than the engine roaring."- William Hutchison, a young man taken from us far too young (16).
I also use the CH products and I do not have the issue you describe. My yoke and pedals work flawlessly.
Cheers, Bert
AMD Ryzen 5900X, 32 GB RAM, RTX 3080 Ti, Windows 10 Home 64 bit
Cheers
Pat
"Some people might say that freedom is being alone in the bush with the only sounds being the murmurs from the birds ... but I believe freedom is at 5000 feet with no other sound than the engine roaring."- William Hutchison, a young man taken from us far too young (16).
I didn't do anything special to get my yoke to work Pat. After a clean install of P3D 3.2 the calibration menu in the sim recognized all axes without any issues. I even stopped using FSUIPC. I have no idea what's going on at your end. Wish I could help...
Cheers, Bert
AMD Ryzen 5900X, 32 GB RAM, RTX 3080 Ti, Windows 10 Home 64 bit
Bookmarks