PDA

View Full Version : FSUIPC help needed


Daveroo
November 6th, 2013, 17:52
it took me awhile but i got it figured out. thing is...i mapped my rudder peddles using FSUIPC but the brakes are reversed,in the simulator ,you need to click the reverse to make them work correctly.....how is this done in FSUIPC?..thanks..
JAllen
November 6th, 2013, 19:03
Go to the brakes calibration page and check the REV boxes. That should do it if I understand the question correctly. Best wishes.
Daveroo
November 7th, 2013, 07:54
ok,thanks..i didnt know you could do that there...
Navy Chief
December 19th, 2013, 04:46
I have a different FSUIPC problem. It was installed just fine until last night, when I installed Orbx Pacific Northwest scenery. During installation of that, I had a message pop up saying some .dll file was corrupted, and did I want it repaired? Naturally I chose to do that. When I booted FSX, I noticed FSUIPC was no longer in the drop down menu for Addons. Is it simply a matter of reinstalling it?

NC
papab
December 19th, 2013, 10:33
NC,
That has happened to me several times with ORBX products, I just re installed FSUIPC
Peter just posted a new FSUIPC4 4.927a

http://www.schiratti.com/dowson.html

Rick
Navy Chief
December 19th, 2013, 14:12
NC,
That has happened to me several times with ORBX products, I just re installed FSUIPC
Peter just posted a new FSUIPC4 4.927a

http://www.schiratti.com/dowson.html

Rick

Just downloaded. Going to give it a try now!

Update: That fixed it. Thanks! NC
GypsyBaron
December 19th, 2013, 14:57
I would guess that the OrbX install may have messed up the 'dll.xml' file with
regards to the FSUIPC4 entry.

I always keep a backup of that file so that I can restore any entries that get messed up by
an 'unfriendly' installer.

The dll.xml file can be found in the same directory as your fsx.CFG file.

Paul