CFS2Bob auto and manual install texture problems

[Robert John]

Attachment 32724Attachment 32723Have anyone else had\got this texture problem.
RJ

OK WAS MY FAULT, HAVE TO SLOW DOWN WHEN INSTALLING AND DO IT PROPERLY THE FIRT TIME.LOL.

[Rami]

RJ,

So, I'm guessing that everything is okay now?

[Pen32Win]

That tower is one of the 5 objects repeated in the RAF Building/BoB packages. Depending on what order you install the Library BGL dictates which texture will show up. The towers in the BoB pak are green and black camo, the ones in the RAF Buildings is Green and Red/Brown. With the blister Hangar it can really mess things up as the Layout of the two textures is different.

[Jagdflieger]

Hmmm.

I've never had a problem with this set of buildings, although the double installation that Pen speaks of would be problematic. I zipped up these files in a separate package so that I can manually install them when needed.

[Pen32Win]

Hey Jagd;

To show you what I mean do this:

1. Place any of these 5 or all of them (Barracks1, Blister, Mobstore, Towerwith or Towerwithout) in a mission. Save the mission and exit MB.
2. Go into your SCENEDB\INF\Scenery Folder and find RAFLib.bgl and add .bak to it.
3. Go Fly the mission and look at the objects. Exit CFS2. You'll probably get missing object msgs
4. Go back to your SCENEDB\INF\Scenery Folder and remove the .bak from RAFLib.bgl and then find BritObj.bgl and add the .bak extension to it.
5. Fly the mission again. You should see the same objects with a different texture. Then exit CFS2.
6. Delete the .bak from the BritObj.bgl. To get back to normal you'll need to add the .bak once again to the RAFLib.bgl, start CFS2, fly, exit CFS2 and then go back and delete the .bak from the RAFLib.bgl.

On my rig it chooses the version from the last bgl added. All 5 of those objects exist in both bgls and it can cause wierd things to happen to the texturing of the objects as you'll see. Your method of keeping them apart and never active at the same time will avoid it for sure.