Hi all,

Again I would just need some confirmation from you, just to ensure I'm not doing anything wrong.

In P3Dv4, using the SSW Tornado, trying to start it from cold&dark, following the checklist.
One of the steps tells to set the X-Drive switches to normal for both engines. I couldn't locate the switches at first, so I just continue the checklist.
=> The engine start switch would not move.

Later on, I realized the X-Drive switches are masked by some red switch cover, which are impossible to move. I can click the switches, but I cannot see their position (label doesn't tell it). Nevertheless, after clicking these switches once each, the engine starter button can finally move left and right, so I can start my engines successfully.

Did I miss a step here ? Is there a way to remove/pull up the switches covers to see the switches ?