Mirage 2000C Released

**DaveB** · May 12th, 2015, 12:14

Oh yeah.. taken as read

Just flew it from Culdrose up to Valley via the Llanberis pass (not the Loop for a change) and as I pulled up to park at Valley.. I popped outside to make sure I was on the T then went back inside and the model had holes everywhere:O I'd obviously pushed the i5 to breaking point.. nearly! Oh dear

ATB
DaveB

**ZsoltB** · May 12th, 2015, 12:34

***hschuit*** · May 12th, 2015, 12:42

Originally Posted by RobM

Without Tacpack, can you still load rockets and tanks, albeit as static displays?
Thanks - Rob

You can use the FSX Payload Settings. Enter the following station - pound values to add your basic tanks/A2A stuff:

STA1: R550 missile= 12, empty pylon= 5
STA2: RP541 tank= 20, S530D missile=13, empty pylon= 5
STA3: RP522 tank= 21, empty pylon= 5
STA4: RP541 tank= 20, S530D missile= 13, empty pylon= 5
STA5: R550 missile= 12, empty pylon= 5

**DaveB** · May 12th, 2015, 13:15

Not that it matters much to anyone except lowly i5 users but I've just run the same flight as before.. 'back to back as it were' with the MV F-15 and disappointingly.. the Mirage appears to be quite a lot more system heavy. The F-15 landed at Valley fresh as a daisy and would've happily flown back I'm sure. Dino's F-14 runs very similar to the F-15 on my rig so I'll try the same flight again tomorrow.

I wonder what the Mirage would run like with ASN running??

ATB
DaveB

***RobM*** · May 12th, 2015, 13:20

Thank you very much hschuit! That works great! I had bookmarked the payload station numbers you gave last August for
the beta version, but they didn't work for the new release.

It's just eye candy of course, and I should spend the extra money for Tacpack some time. But this does look a lot better
than empty pylons, and really adds to an already excellent plane.

Thanks again - Rob

**dhazelgrove** · May 13th, 2015, 05:55

Dave

**hae5904** · May 13th, 2015, 08:33

Some P3D v2/TacPack fun........ Mirage style of course.

Hank

**JimmyRFR** · May 13th, 2015, 09:00

Originally Posted by dhazelgrove

Dave

Dave, do you mind sharing which scenery that is?

**Scandinavian** · May 13th, 2015, 09:43

I would also like to know that. And any other recommendations for good scenery where the Mirage feels at home?

**res non verba** · May 13th, 2015, 13:10

...French airbases from Skydesigners ...many bases to choose from.

http://secure.simmarket.com/skydesigners.mhtml

**dhazelgrove** · May 14th, 2015, 00:28

Originally Posted by JimmyRFR

Dave, do you mind sharing which scenery that is?

Not at all. It's the payware BA115 Orange-Cambrai (LFMO) from Skydesigners - available from Simmarket.

Dave

***hschuit*** · May 14th, 2015, 00:40

I bought Cambrai-Epinoy last month when they did their annual sales and it looks very nice but the traffic (MAIW Mirages) refused to take off. I found several AFCAD issues such as missing / wrong hold-short nodes and unconnected parking spots which had to be fixed with ADEX.
Did anyone have these issues with other Skydesigners bases?

**hae5904** · May 14th, 2015, 00:58

Yes Henk , actually with all of them. Also there are some issues with Global installed (global mesh).

Hank

**ZsoltB** · May 14th, 2015, 01:39

**dhazelgrove** · May 14th, 2015, 02:24

Visiting LFSR.

Dave

**JimmyRFR** · May 14th, 2015, 08:44

Originally Posted by dhazelgrove

Not at all. It's the payware BA115 Orange-Cambrai (LFMO) from Skydesigners - available from Simmarket.

Dave

Thank you sir!

**Stickshaker** · May 20th, 2015, 11:52

Originally Posted by hae5904

There is Dave, very elegant and simple..... the actual starting procedure !!

(4 switches actually.... 2x fuel pumps, 1x starter pump and the starter switch)

Hello Hank,

When I start the way you explain it, the lamp on the landing gear handle keeps blinking at me after retraction intermittently , and after five minutes or so the warning light 'panne' goes on and the engine stops. I have more than 60% fuel according to the FASX loadout window. I posted this at the M2M forum bit did not get a reply yet. Do you know what U am doing wrong?

**hae5904** · May 20th, 2015, 13:52

PM send Stickshaker !

**Stickshaker** · May 20th, 2015, 14:35

Thanks, Hank, I'll try out your advice tomorrow.

***Lawman*** · May 25th, 2015, 06:36

Originally Posted by hschuit

You can use the FSX Payload Settings. Enter the following station - pound values to add your basic tanks/A2A stuff:

STA1: R550 missile= 12, empty pylon= 5
STA2: RP541 tank= 20, S530D missile=13, empty pylon= 5
STA3: RP522 tank= 21, empty pylon= 5
STA4: RP541 tank= 20, S530D missile= 13, empty pylon= 5
STA5: R550 missile= 12, empty pylon= 5

I took the liberty to update the list above so simmers without TacPack know how to display the bombs, anti-radiation and anti-ship missiles as well. My additions in red, though I'm not sure about the cannons.

STA1: R550= 12, empty pylon= 5, no pylon=0
STA2: RP541 tank= 20, S530D=13, GBU12 LGB=16, Matra LRF4 rocket pod=17, AS37 Armat ARM=18, AM39 Exocet ASM=19, empty pylon= 5, no pylon=0
BL1: GP82 slick=14, GP82 retarded=15, empty pylon= 5, no pylon=0
BL2: GP82 slick=14, GP82 retarded=15, empty pylon= 5, no pylon=0
STA3: RP522 tank= 21, empty pylon= 5, no pylon=0
BL3: GP82 slick=14, GP82 retarded=15, empty pylon= 5, no pylon=0
BL4: GP82 slick=14, GP82 retarded=15, empty pylon= 5, no pylon=0
STA4: RP541 tank= 20, S530D= 13, GBU12 LGB=16, Matra LRF4 rocket pod=17, AS37 Armat ARM=18, AM39 Exocet ASM=19, empty pylon= 5, no pylon=0
STA5: R550= 12, empty pylon= 5, no pylon=0
LGUN: DEFA 554 cannon loaded=11
RGUN: DEFA 554 cannon loaded=11

Very small detail btw: in the TacPack load-out manager, the Exocet-missile is incorrectly labeled as AS39.