Question for CH Yoke Users
Results 1 to 5 of 5

Thread: Question for CH Yoke Users

  1. #1

    Question for CH Yoke Users

    Hi: Quick question: On the CH Yoke, does the shaft of the yoke extend out of the back of the case of is it totally enclosed?...This will make a difference as to whether or not it will fit on my table...Thanks,

    Steve
    US Army Medical Department
    Retired Lieutenant Colonel

  2. #2
    It goes out the back.

  3. #3
    Quote Originally Posted by LTCSZ View Post
    Hi: Quick question: On the CH Yoke, does the shaft of the yoke extend out of the back of the case of is it totally enclosed?...This will make a difference as to whether or not it will fit on my table...Thanks,

    Steve
    Out the back. I found a picture on the internet.
    You will need clearance when it's full forward.

    Picture is by Mike Stiteler.
    Kiwikat was faster today...
    "No, I'm not a good shot, but I shoot often." - Theodore "Teddy" Roosevelt

  4. #4
    The Saitek yoke, on the other hand, is fully enclosed.

  5. #5
    It will take 8 1/2 inches from the face of the desk. That's at full down elevator.
    Curt

Similar Threads

  1. Question for AFX users.
    By binarkansas in forum Landscapers & Architects
    Replies: 2
    Last Post: July 16th, 2013, 14:24
  2. Question for ETO users...
    By Rami in forum CFS2 General Discussion
    Replies: 16
    Last Post: October 11th, 2010, 18:17
  3. Question for Users of CH Yoke
    By LTCSZ in forum FSX General Discussion
    Replies: 5
    Last Post: July 31st, 2009, 10:47
  4. CH Yoke Question
    By LTCSZ in forum FSX General Discussion
    Replies: 5
    Last Post: December 28th, 2008, 03:48

Members who have read this thread: 0

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •