Sim Skunk Works FRF-104 released

[Deacon211]

I held off for the single seat version. I’m sad to see that even the non-marketplace version won’t have weapons. But the Starfighter is such a beautiful bird even clean that I can’t resist her.

[DennyA]

I'm not convinced there aren't weapons hiding in there. All those "easter egg" entries on the fuel and weight section... Might just be a case of having to figure out the proper weights to put in each entry.

[ZsoltB]

SIM SKUNK WORKS
LOCKHEED TF-104 G
version 3.1 available at SimMarket, soon on other vendors:
JustFlight, ORBX, Aerosoft

CHANGELOG VERSION 3.1.
- new sounds (internal)
- kneeboard added
- retrieving different airframe accomplished with barcodes
- gunsight, ground speed error readout, simple HUD added as easter eggs
- Q7 Martin Baker seat added on 2 new liveries
- Documentation revised
NOTE FOR PAINTERS:
Retrieving different airframe and seat is done using barcodes, if painters want add new liveries they should read tf-104g_hints.pdf in /docs looking at "BARCODES" paragraph at page 13

BUG fixed
- Fixed bug on throttle axis
- fixed bug on TAL NUMBER customization

https://www.facebook.com/simskunkworks/

[jankees]

sea25 by JanKees Blom, on Flickr

34-7 by JanKees Blom, on Flickr

[ZsoltB]

there is a little oddity....
wingtip fuel tanks

[Manschy]

Zsolt, is the view point exaclty centered?

[ZsoltB]

Zsolt, is the view point exaclty centered?

Yes, you should check it out too

[Yossarian1943]

Hi members,

using the latest version of MSFS & FRF-104G (bought via SIMMARKET) I have an issue with the autopilot. In cold & dark mode the AP master switch is in OFF position. Using the kneeboard EPU toggle the AP master switch automatically switches to ENGAGE. But even after full startup with navigation alignment the annunciator panel shows "AUTOPILOT DISCONNECT". Also I cannot move the AP master switch manually. Did a new installation of the aircraft, but this did not solve the problem. Any suggestions for me please? Something overseen in the manual? Or am I just too stupid to handle this beauty?

greetings Marc

[Tom Clayton]

It's probably related to the update. I'd hold off until the authors can address the issue.

[Priller]

The update for the latest iteration of MSFS is available on simmarket!

Priller