FS9 Henschel Hs 123 2D panel.zip

[michaelvader]

A new entry has been added to Add-Ons Library, category FS 2004 Panels

Description: FS2004 ACOF FS9 Henschel Hs 123 panel

This zip contains a new 2D panel for the Henschel Hs 123 (henschel_hs123.zip) the VC has been adapted to the 2D panel as far as I could and also there is an alternative aircraft.cfg file.

By: Michael "Papi" Vader

To check it out, rate it or add comments, visit FS9 Henschel Hs 123 2D panel.zip
The comments you make there will appear in the posts below.

[Mick]

Nice work!


Is this meant for Scrubby's model or Chris Herring's? Or should it work for either one?

(I know the 2D would work for either model, but maybe not the VC?)

[michaelvader]

Hi Mick,
I used Scrubbies FS9/FSX Hs 123 as base.
If you use this model also the VC will fit even it is very summary.
Also the joined aircraft.cfg is done for Scrubbies model.
Now when you fly at 1000meters altitude with 1.0 ata manifold pressure,
you obtain about 285 km/h of speed and the trim is neutral.
As it should be
Yours
Papi

[huub vink]

Thanks Papi. As always very nice work

Cheers,
Huub

[Mick]

Hi Mick,
I used Scrubbies FS9/FSX Hs 123 as base.
If you use this model also the VC will fit even it is very summary.
Also the joined aircraft.cfg is done for Scrubbies model.
Now when you fly at 1000meters altitude with 1.0 ata manifold pressure,
you obtain about 285 km/h of speed and the trim is neutral.
As it should be
Yours
Papi

Thanks Papi,

I have that model and I'll try your panel. It looks great in the screen shot and I'm sure it will look great in the sim.

[michaelvader]

Good evening friends,
just a little advice,
to make the whole thing a bit nicer I use the sound from Nigel Richards fine Avro Tutor
They fit perfectly to this plane
Yours
Papi