Hi all,

Been enjoying this lovely aircraft for a few years now, but only for short carqual type hops.

But looking to take longer trips involving IFR legs, so I need to figure out how radio freqs get input. I’ve cycled the modes, and the UFC will allow me to type the numbers, but they don’t change the radio freq. I can change them on another plane and then have that correctly shown if I hop back into the Hornet, but that’s a dumb workaround. The good news is once the freq is in, then the VOR and/or ILS data shows fine in the MFD. But it’s the input that’s boggling me.

Anyone have a step by step on how to do this?

Many thx!

D