Hi,
I'm using AirWrech v1.01.77 to edit the thrust/drag and afterburner thrust curves for an F-16 addon. I used a post here at Sim-Outhouse as a tutorial, but something has gone awry.
I entered the Vmax in the Specs tab, then adjusted my Vmax Altitude, Static Thrust, N2 RPM, and TSFC. Then I clicked "Repair Jet Engine" and observed changes in the Thrust Required and Thrust Available curves.
I then edited the AB Stages, AB TSFC, and the AB table. All of my curves match the desired performance, and the file saves without any errors.
However, when I go into FSX:A, the airplane will not rotate until about 320kts, and when it does, the pitch is uncontrollable and within about 3 seconds, the airplane starts flipping end over end.
I've tried not clicking on the "Repair Jet Engine" button, manually adjusting the Max Mach Drag, even resetting the Balance, but nothing fixes the issue.
For what its worth, the thrust has indeed been affected by the changes, so at least that works.
Any ideas whats going on here?
Thanks,
Nick
Bookmarks