ive asked this before and still havent got it to work.

i have two saitek throttles (three,more on that later) that i use for twins etc.ive tried to set them up using spadnext,using the "with reverser"..using the "without" (not sure of the exact wording,dont slay me) ,ive tried it by not suing spadnext and just using FSUIPC,ive not tried anything in P3D itself,,,is that a thing?..

basically,can someone guide an idiot through it?.

so,i broke off the mixure lever for engine two on my duel throttle setup,i have a new one now,as i tried to repair it using super glue...i dropped a single small drop on the end of the lever,and it ran right down the lever arm and into the pot(is that what its called ? ) and it stuck it solid.i looked at the bottle again...id grabbed the super thin CA,not my thick..i have 5 bottles,and seems i put them in the wrong holders...so now i have three throttles,with 8 working levers...what should or can i do with the last two?..