Hello Smilo,
OK! Thanks. The tail-skid bleeds through from almost any forward horizontal or forward-upward angle.
Iīd put that in so the plane wouldnīt have to drag the tail on the ground, thinking of converting it into a wheel later.
It is obviously un-sequenced, to be found at the end of the FUSE SA in the Tail Assembly.
I suppose taking it out into a separate SA, using a bottom rear-fuslage seal and a Jump Plane instruction it could be fixed.
You mention issues in plural, so there must be more. Letīs see...
Cheers,
Aleatorylamp
Bookmarks