Originally Posted by
triflyman
The area of the aircraft.cfg file the relates to the steering is about 3/4th of the way down and looks like this:
[contact_points]
//0 Class <0=none,1=wheel, 2=scrape, 3=float>
//1 Longitudinal Position (feet)
//2 Lateral Position (feet)
//3 Vertical Position (feet)
//4 Impact Damage Threshold (Feet Per Minute)
//5 Brake Map (0=None, 1=Left, 2=Right)
//6 Wheel Radius (feet)
//7 Steer Angle (degrees)
//8 Static Compression (feet) (0 if rigid)
//9 Max/Static Compression Ratio
//10 Damping Ratio (0=Undamped, 1=Critically damped)
//11 Extension Time (seconds)
//12 Retraction Time (seconds)
//13 Sound Type
//14 Airspeed limit for retraction (KIAS)
//15 Airspeed that gear gets damage at (KIAS)
point.0=1, -55.75, 0.0, -2.875, 1600.0, 0, 0.93, 180.0, 0.44, 2.00, 0.6, 0, 0, 0, 0, 0
//point.0=1, -55.75, 0.0, -2.875, 1600.0, 0, 0.93, 72.0, 0.44, 2.00, 0.6, 0, 0, 0, 0, 0
point.1=1, -18.50, -9.12, -9.95, 1600.0, 1, 1.89, 0.0, 0.52, 1.33, 0.50, 8.0, 11.0, 2.0, 166.0, 166.0
point.2=1, -18.50, 9.12, -9.95, 1600.0, 2, 1.89, 0.0, 0.52, 1.33, 0.50, 7.5, 16.0, 3.0, 166.0, 166.0
The lines in question above are in Italics. All you need to do is change them from as they are to as follows:
//point.0=1, -55.75, 0.0, -2.875, 1600.0, 0, 0.93, 180.0, 0.44, 2.00, 0.6, 0, 0, 0, 0, 0
point.0=1, -55.75, 0.0, -2.875, 1600.0, 0, 0.93, 72.0, 0.44, 2.00, 0.6, 0, 0, 0, 0, 0
All I have done is added the "//" from where it starts "point.0=1...." and removed the "//" from where it says "point.0=1.....".
In any configuration file adding the "//" makes it not to be read by the program...while removing "//" makes the line be read by the program.
Hope that helps.
Bookmarks