Printable View
skyhawka4m,Quote:
Originally Posted by skyhawka4m
Absolutely nothing, I run a bog standard FSX install on a drive that I hot swap in so I can test additions outside of my 'real' FSX installation, just in case anything goes wrong.
Could it be you have something in yours that boosts the shine?
Look for envmap.bmp in root texture folder, it should be exactly 42.7k.
That's about all I can think of.
:encouragement:
Here is the paintkit for the DC-8 Jetliner 50 to 70 series:
http://cdn.mastertronic.com/justflig...0_PaintKit.zip
Has anyone got the 50-70 paintkit? The link no longer seems to work and the JF website only has the 10-40 kit.Quote:
Originally Posted by RAS_JF
Send me your e-mail adress in a Private message and i can send you the paintkit.Quote:
Originally Posted by SkippyBing
Cheers,
Randy
PM sent, much appreciated!
I'll take a copy too...Quote:
Originally Posted by Randy92
PM on the way
I've tested the 50 to 70 series for the first time and found that the early and late 61 series and 63 series cockpits bring FSX to a standstill. I couldn't trace this behavior down to a gauge (removed them all and didn't see any improvement), so I assume that the model file itself is to blame.
All other variants in the package perform nominally, albeit with a general framerate hit (the variants without FMC perform slightly better).
For what it was worth, I tried to run the "bad" models through MCX in the hope that a reexport might fix whatever bad pieces are in them. However, each and every time, the result was that XToMDL crashed because it ran out of memory. Can't blame it. Each cockpit variation has around 350000 polygons and over 1000 drawcalls and produces a 50 MB .x file (default 747: 28600 polys, 68 drawcalls, 4.5 MB .x file). :dizzy:
By the way: "High Performance" models only apply to the exterior, by the way, so you may safely leave the aircraft in "High Quality".
And speaking of "High Performance" mode...
If FSX/P3D throws an error when selecting the "high performance" configuration 53 Series, go to "JF_Douglas_DC8-53\model.53_std\model.cfg" and change
interior=JF_DC-8-53_int
to
interior=..\model.53\JF_DC-8-53_int
then restart FSX/P3D.
That should fix it.