Questions About Trim Gauge
A few questions about the new "Trim Gauge" in the Alpha S-55 . Got installed ok and it shows up I believe when I hit Shift + 4 . A little rectangular gauge shows with three parameters :pitch , bank , and yaw . Value of zero is showing . Do I click on this gauge and change the value(negative) because when attempt this I can't insert any numbers in the gauge . When I figure this out I understand fron the ReadMe file that any changes I make creates a confuration file (Somewhere?) and this config file must eventually end up in the main S-55 folder ?
Rich
(Goal changing nose pitch down to level as discussed here in this thread)