CFS2 Piers and Breakwaters v. 1.1 uploaded

[xavierb]

Ten years after, I have uploaded an update of my CFS2 piers and breakwaters. MaskRider was told by another user, Voyager, that one of the slopes of a pier was misplaced, and he was fully right, so I have fixed it a couple of hours to remember how was it done and making old 32-bit software to work in my new rig.

I also have included Usio's light effects in the package. I hope to have credited him enough in the readme file!

Well, that's all. Have fun!

Xavier

[MaskRider]

Thank you, Xavier!!!
:ernaehrung004:
Chris

FEI: Here is what the issue was. It involved the breakwater-small-angle at Noda Port on Ishigaki-Shima in the Sakishima-Gunto pack. It was the only place I used it in the entire pack. It probably would have gone unnoticed for another 10 years if I hadn't put a float-plane start point that faced right into it and if Voyager hadn't decided to use the start point and seen it. ;^)

Before:
http://www.mask-rider.net/MaskRider2008/resources/small-breakwater-angle-viewed-from-west.jpg
After
http://www.mask-rider.net/MaskRider2008/resources/xaviers-breakwater-angle--fixed-00.jpg

Thanks again, Xavier!

[Rami]

Xaiverb,

Thank you, this is outstanding work!

[xavierb]

http://www.sim-outhouse.com/soh_ftp/uploads/imageuploads/776814602363732908.jpg
A new entry has been added to Add-Ons Library, category CFS 2 Scenery Add-Ons

Description: Updated version of my set of freeware piers and breakwaters for Combat Flight Simulator 2. All objects set as infrastructure and able to be used in Mission Builder and also as GSL objects.

By Xavier Berdaguer. See requirements, additional credits and installation instructions at file install_readme.txt into this package.

This 1.1 version fixes a problem with one of the breakwaters and also includes all required third-party add-ons.

To check it out, rate it or add comments, visit CFS2 Piers and Breakwaters v. 1.1 - 2016.zip (http://www.sim-outhouse.com/sohforums/local_links.php?linkid=21157&catid=45)
The comments you make there will appear in the posts below.

[Rami]

Xavierb,

This is going to sound like a really dumb question, but can I remove the old version from the library? In other words, is this a full replacement?

[miamieagle]

Very nice!

thank you:applause:

[voyager]

Xavierb,

Thank you!

vopyager

[xavierb]

For updating, just replace the .BGL file with the new one. That's it!


Xavierb,

This is going to sound like a really dumb question, but can I remove the old version from the library? In other words, is this a full replacement?

[Captain Kurt]

Very nice to see you here again Xavier :jump:

[kelticheart]

Very nice to see you here again Xavier

Oh, yes! I'll second that! :wavey:

Thank you for this update, Xavier!
:applause: :applause:



KH :adoration: