Daveroo
April 23rd, 2015, 10:27
i have the sietek switch panel and cessna trim wheel,along with the CP products eclipse yoke and two throttle quads.i plane on a generic fsuipc setup for now,just to get to flying.
first question,can i use the switch panel for four engined AC?..can i go to the batterys "both"..and the use the start "button" to start the engines one at a time? yes i know there are steps to do inside the cockpit too.
and if im using the trim wheel,can i use the "trim wheel" on the eclipses yoke for some other operation?..and an example would be?...remember im just doing the 4 engine simple setup for now..i want to fly now..and detail later.
thanks
Dave
first question,can i use the switch panel for four engined AC?..can i go to the batterys "both"..and the use the start "button" to start the engines one at a time? yes i know there are steps to do inside the cockpit too.
and if im using the trim wheel,can i use the "trim wheel" on the eclipses yoke for some other operation?..and an example would be?...remember im just doing the 4 engine simple setup for now..i want to fly now..and detail later.
thanks
Dave