gray eagle
February 2nd, 2015, 07:26
I am experiencing an unusually long prop spin down time with the Abacus C-2. After shutdown, the blade will eventually slow down (about 45 sec ~) then when it just about comes to a halt
it will start to rotate in the opposite direction for awhile. It looks like it is trying to start up but the blades are spinning in the opposite direction; it eventually stops but that is way too long
for turbo prop blade to come to a dead stop.
Any one else experience this and maybe know of a fix for this?
Thanks in advance.
BTW I tried adjusting the PROP MOI and that didn't phase it at all.
it will start to rotate in the opposite direction for awhile. It looks like it is trying to start up but the blades are spinning in the opposite direction; it eventually stops but that is way too long
for turbo prop blade to come to a dead stop.
Any one else experience this and maybe know of a fix for this?
Thanks in advance.
BTW I tried adjusting the PROP MOI and that didn't phase it at all.