46_trap
October 21st, 2010, 14:01
If the paddle for the yoke is reversed, when you press the left side of the paddle, the aircraft turns right, then you are going to change the axis. After you change the axis it will work correctly in CFS3 and FSX.
Open the CH Manager. Select the Eclipse yoke and then go into calibration. Open the axis page,the axis for the paddle is R, change the axis to reverse and center. exit the axis and calibrate the yoke. there is no toe brake on the paddle, so you will have to set up your brakes using buttons.
Have a good flight
Open the CH Manager. Select the Eclipse yoke and then go into calibration. Open the axis page,the axis for the paddle is R, change the axis to reverse and center. exit the axis and calibrate the yoke. there is no toe brake on the paddle, so you will have to set up your brakes using buttons.
Have a good flight