Working Solution

[sc7500]

I Actually Have a Relevant Question.

Huzzah !

While working with some older German A/C skins, I discovered one [a Ju-88] with a non see-thru canopy. Using DXTBmp and PSP, I was able to clear the canopy by creating an Alpha layer.

However, it's just a little TOO clear now, and looks.... odd.

Is there a method to "tint" the glass that does not require manipulating the MDL file ?

Thanx in advance :salute:
SC
:kilroy:

[oldwheat]

Send over the plane & skin & I'll take a look.

[OBIO]

Here's the combo that I have had the best success using:

Paint the glass on the texture file with RGB code 167, 167, 167. For the alpha, use RGB code 129, 129, 129.

OBIO

[AGAS 5]

In combination with Obio's suggestion, don't forget to vary the level of transparency in the alpha. Black is fully transparent, levels of grey lesser so.

Pete

[sc7500]

Thanks, Cats - I will try these suggestions ASAP !

OldWheat, you have a PM...

SC
:kilroy:

PROGRESS REPORT:

The combination of OBIO and AGAS solutions has made life a lot more bearable for my Flight Crews !

Thank You, All !

[tonybones2112]

I've found many FS2K and CFS1 planes have this, it's annoying. I've found also many of the RAF662 site's planes for CFS2 have this glass problem.

Which model Ju-88 is that SC? That gun protruding from the lower nose makes for a good strafer.

Bones

[sc7500]

I ...Which model Ju-88 is that SC? That gun protruding from the lower nose makes for a good strafer...


According to the Aircraft Config file, its an Alphasim CFS2 JU88-A-14 Version 1.0, T-Man !

SC
:kilroy: