Lcac...?

[Seahawk72s]

I'm hoping someone can identify this LCAC used in the Deltasim LHD manual.
(Robert is not sure where it came from.) I'm pretty sure its not the Bruce Fitzgerald
model because of the paint job and the way the skirt is attached to the hull.

Thanks....

[Seahawk72s]

Just one bump to keep it seen...:wavey:

[JAK_021]

Good question. Was wondering that myself... Anybody?

[jeansy]

Fsaddons?

Otherwise it might be a wip from DS

[gp183601]

It might just be a stock 3D model he's using. Looking at the image it's very similar to an LCAC I found on my hard drive - certainly when I compare the image of the fan and the stern ramps.

http://www.fsfiles.org/flightsimshotsv2/images/2017/11/13/LCAC.md.jpg (http://www.fsfiles.org/flightsimshotsv2/image/GImu)

I've no idea where I got this model from and there's nothing to indicate its usage in the readme (royalty free or otherwise) so that might be why he hasn't included it in any package (might not be available for commercial use hence he used it for illustrative purposes only and did not include it in any package).
If I can figure out where I got this from it might shed some light.

Cheers
Gaz

[Seahawk72s]

It might just be a stock 3D model he's using. Looking at the image it's very similar to an LCAC I found on my hard drive - certainly when I compare the image of the fan and the stern ramps.

http://www.fsfiles.org/flightsimshotsv2/images/2017/11/13/LCAC.md.jpg (http://www.fsfiles.org/flightsimshotsv2/image/GImu)

I've no idea where I got this model from and there's nothing to indicate its usage in the readme (royalty free or otherwise) so that might be why he hasn't included it in any package (might not be available for commercial use hence he used it for illustrative purposes only and did not include it in any package).
If I can figure out where I got this from it might shed some light.

Cheers
Gaz

I think you're exactly right, Deltasim used it only for illustrative purposes.
I'll look forward to hearing its provenance and if you can share it.
Thanks...