hubbabubba
December 12th, 2005, 14:19
Hi sparks!
While experimenting with version 1.01.21 of AirWrench I noted that wing's scrape points seemed to be defective. I thought this was my mistake until I loaded your "cfs1_spit_mki.zip" aircraft.cfg and AIR files and installed them in the Spit.
Despite more-or-less identical scrape points in modified and original flying model, it seems that at least wing's one are out of place or non-existent. I've taken two pictures showing portside wing scraping the ground while portside wheel is still in contact with the ground too.
http://img205.imageshack.us/img205/3001/scrapefs9dh.jpghttp://img205.imageshack.us/img205/208/scrapeaw8ml.jpg
Nose and tail scrape points may also be affected but I'm not good enough a pilot to test this.
Returning to test.
Hubbabubba
While experimenting with version 1.01.21 of AirWrench I noted that wing's scrape points seemed to be defective. I thought this was my mistake until I loaded your "cfs1_spit_mki.zip" aircraft.cfg and AIR files and installed them in the Spit.
Despite more-or-less identical scrape points in modified and original flying model, it seems that at least wing's one are out of place or non-existent. I've taken two pictures showing portside wing scraping the ground while portside wheel is still in contact with the ground too.
http://img205.imageshack.us/img205/3001/scrapefs9dh.jpghttp://img205.imageshack.us/img205/208/scrapeaw8ml.jpg
Nose and tail scrape points may also be affected but I'm not good enough a pilot to test this.
Returning to test.
Hubbabubba